Skip to main content
11 events
when toggle format what by license comment
Jan 1, 2023 at 11:06 history bumped CommunityBot This question has answers that may be good or bad; the system has marked it active so that they can be reviewed.
Dec 2, 2022 at 10:55 answer added Shark timeline score: -1
S Oct 22, 2021 at 20:00 history bounty ended CommunityBot
S Oct 22, 2021 at 20:00 history notice removed CommunityBot
Oct 18, 2021 at 7:51 comment added Fahad Check out these links: (1) youtube.com/watch?v=Ji2-2ehLCOQ (2) youtube.com/watch?v=4ElZec033vQ (3) youtube.com/watch?v=gSifTiR_e2E (4) youtube.com/watch?v=XMZrUPBt-7M
Oct 15, 2021 at 1:46 comment added Abel the button likely handles its own grounding so one question is whether you have access to that device's ground... if not for a purely isolated device, you'd need to mirror their two electrodes. you then drive a voltage between your two (direction matters for this) to pretend to not touch or connect them to the same (both to either high or low) to simulate a touch
Oct 14, 2021 at 21:00 history tweeted twitter.com/StackArduino/status/1448755518630211586
S Oct 14, 2021 at 18:15 history bounty started Iulius Curt
S Oct 14, 2021 at 18:15 history notice added Iulius Curt Draw attention
Jul 30, 2020 at 2:04 comment added Delta_G It's all about capacitance. The micro is putting a voltage on that cap sensor and measuring how long it takes to fall or rise. That gives a measure of capacitance. When you put your finger you change the capacitance. Perhaps you could put a second plate there and get the capacitance right to not trigger the button and then have a capacitor that you can switch in to make it higher and trigger it. Not entirely sure how you'd do that, but maybe it gives you a place to start.
Jul 30, 2020 at 1:05 history asked Damn Vegetables CC BY-SA 4.0