I have 3 LEDs powered by an Arduino; each LED has its own flash rate.
Now I want it to be powered by an external 12V power source and still have the flashing function of the Arduino?
-
1You will need a transistor or a MOSFET to do that (one per LED). Just google that and you'll find many examples how to do it. On Arduino.SE, there have also been many questions about this topic.jfpoilpret– jfpoilpret2016-12-04 08:36:44 +00:00Commented Dec 4, 2016 at 8:36
-
Thank you very much! I tested it and it works perfectly! :DAustin Grant– Austin Grant2016-12-04 08:51:41 +00:00Commented Dec 4, 2016 at 8:51
Add a comment
|
3 Answers
Use a N-channel MOSFET, wire load to drain pin, source to (common) ground, and place a 1 kilo-ohm resistor in series with your arduino pins. Bear in mind that MOSFETs respond to voltage, not milliamps, on the gate - get one that responds well to 5V logic.
-
You do not need a series resistor with a MOSFET (although it does no harm). If using a bipolar transistor it is essential.Milliways– Milliways2016-12-04 22:38:11 +00:00Commented Dec 4, 2016 at 22:38
-
@Milliways We discussed that before. Different strokes I suppose.user400344– user4003442016-12-05 00:12:02 +00:00Commented Dec 5, 2016 at 0:12
Or you could use a relay. Many small ones available for a couple of dollars.
-
Using a relay for such circuit would be just annoying because of "clicking" on relay.Adam Rosiek– Adam Rosiek2017-03-05 00:34:57 +00:00Commented Mar 5, 2017 at 0:34
-
1Hmmm, I didn't read that that was a criteria, not to mention that there are small, quit, solid state relays.nkuck– nkuck2017-03-05 00:38:45 +00:00Commented Mar 5, 2017 at 0:38
As has been mentioned, you could use an N Channel MOSFET, but preferably look for a Logic Level MOSFET. These are capable of being turned on by lower voltage levels such as on the pins of an Arduino.
Having said that, i have used two non logic level MOSFEt's in Arduino projects successfully. They are the IRF3205 and IRF 520 - both are readily availalable and will work OK with the Arduino output pins for your low-current-driving-an-LED requirement.
