I have a nodemcu v3 and I'm trying some basic stuff
I installed the esp8266 board in Arduino IDE and then I uploaded a blink example.
But now I'm trying to upload Lua code using ESPLorer but I doesn't work properly. I press in open and set the baud rate to 115200 but I just get some infinite Chinese letters.
Should I reinstall the firmare or something?
There is a very good answers at https://stackoverflow.com/a/43509569/131929 and https://stackoverflow.com/a/47510019/131929.
Should I reinstall the firmare or something?
First you should make up your mind whether you want to conveniently program in Lua or whether you want to stick with Arduino (running on the NodeMCU-clone board). It is an either-or question. Flashing on of them to the module will erase the respective other.
And no, in case you want to use the NodeMCU firmware, you should not use those outdates binaries from 2015. Build a recent version conveniently in the cloud: https://nodemcu.readthedocs.io/en/latest/en/build/.
P.S. if you're interested why I call yours a clone board you may want to read https://frightanic.com/iot/comparison-of-esp8266-nodemcu-development-boards/ from yours truly.
You must erase the flash of your NodeMCU before a new upload. If you ignore that, your software don't run appropriately. To do that, I'm using esptool:
python esptool.py --port COM9: erase_flash
In that example COM9: is the name of my USB/serial interface.
After that you can flash for example your ESP8266 with that line of code to add a boot part:
python esptool.py --port COM9: write_flash -fm dout 0x00000 boot_v1.5.bin
Use the preview line of code and adapt it to upload other parts of the map of the flash memory.
