in VHDL, I can easily do this:
constant cmdbytes : bytearray(0 to Total) := (x"05", x"00", x...};
I want synthesizable constants so that when the FPGA starts, this array has the data I supplied. These registers are wired to VCC or ground to represent 1 or 0. I can then use them to generate a waveform. Also I would like to have 2D byte array which is 3D in verilog world.
If you're just using the array to pull out one value at a time, how about using a case statement? Granted, it's a long-winded way of doing it, but you could always write a script to write the RTL for you.
reg [7:0] value;
reg [7:0] i;
always @(posedge clk or negedge rst_n) begin
if(!rst_n)
i <= 8'd0;
else
i <= i + 1;
end
always @(*) begin
case(i)
8'h00: value = 8'd0;
8'h01: value = 8'd34;
...
endcase
endcase
Another way is to use an initial statement. As far as I'm aware, FPGA synthesis tools will allow you to set initial values for arrays in the following manner. Again, a script to write this may be the way to go.
reg [0:35][7:0] my_array;
initial begin
my_array[0] = 8'd45;
my_array[1] = 8'd26;
...
end
And if your FGPA synthesis tools support some SystemVerilog, you'll be able to initialise the array like so:
reg [0:34][7:0] my_array = '{ 8'd90, 8'd34, ... }; // note the '{
module test (
input [7:0] p1_sa, // i
input [7:0] p1_sb, // i
output [7:0] p3, // o
output [7:0] p3b // o
);
logic [7:0] array2d [7:0] = {99,124,119,123,242,107,111,197};
assign p3 = array2d[p1_sa];
assign p3b = array2d[p1_sb];
endmodule
I tried the above system verilog code and it is working fine in modelsim and Vivado.
An alternative to the case statement approach is to use a function to access values.
Example for an "array" of size 4 containing 8 bit constants:
function [7:0] cmdbytes;
input [1:0] index;
reg [7:0] t[0:3];
begin
{
t[0],t[1],t[2],t[3]
} = {
8'h05, 8'h00, 8'h5b, 8'h45
};
cmdbytes = t[index];
end
endfunction
One can access the constants like so:
wire [7:0] value0;
wire [7:0] value1;
wire [7:0] value2;
wire [7:0] value3;
assign value0 = cmdbytes(2'd0);
assign value1 = cmdbytes(2'd1);
assign value2 = cmdbytes(2'd2);
assign value3 = cmdbytes(2'd3);
